[App_rpt] DTMF processing?

[James Nessen]

So, after a little more troubleshooting this morning, I ran into the  
following:

I had to change my funcchar to something other than * (because my  
controller sees the * as local control and drops PTT towards the  
other linked ports), I noticed that when I did, I was not able to  
control the node (ran rpt reload under asterisk console).  However,  
once I changed it back to *, I was able to DTMF the node around..

On my other node, I have my funcchar set to a number instead of the *  
and it works fine, what are the limitations to setting the funcchar  
command under rpt.conf?

Thanks.

Jim / K6JWN

On Mar 11, 2008, at 5:04 AM, Steven Henke wrote:

> Jim,
>
> In rpt.conf try...
> propagate_dtmf = yes   ; DTMF sent to system from link gets
>      ; repeated onto main system output (optional)
>
> 73,
> Steve Henke, W9SH
>
> On Tue, Mar 11, 2008 at 1:50 AM, James Nessen  
> <nessenj at jimsoffice.org> wrote:
> I have just setup another node and I am having an issue with DTMF,
> the node is decoding my dtmf just fine, however it's not actually
> going through and processing anything.  I can control it via rpt fun
> <node> <cmd> and that works fine, but something is missing..
>
> The configs were copied over from a good known working node (and node
> numbers changed)..
>
> What did I miss?
>
> Thanks.
>
> Jim / K6JWN
> _______________________________________________
> App_rpt mailing list
> App_rpt at lists.illiana.net
> http://lists.illiana.net/mailman/listinfo/app_rpt
>
> _______________________________________________
> App_rpt mailing list
> App_rpt at lists.illiana.net
> http://lists.illiana.net/mailman/listinfo/app_rpt