[App_rpt-users] Ok, this was puzzling.

[Scott Weis]

It's normal, while in remote control mode the controlling node stays keyed
until the #.

 

From: app_rpt-users-bounces at ohnosec.org
[mailto:app_rpt-users-bounces at ohnosec.org] On Behalf Of Alan Adamson
Sent: Wednesday, June 06, 2012 10:42 PM
To: 'app_rpt mailing list'
Subject: [App_rpt-users] Ok, this was puzzling.

 

I have a full duplex connection between my allstar server and my repeater
via a RTCM acting just as a ROIP box, not a voter.

When I connect that node to another node on my box and then connect it in
*command mode*, it causes the repeater to stay keyed down even though I'm
not bringing it up via the repeater input .. UNTIL I finish the command mode
and press the "#", then it go back to tracking the repeater input.

Is this normal?  It works in all other modes as you would expect so no it's
not an inverted COR, etc. It only does this when you put a node that's
connected to the repeater node into command mode.

Very bizarre. it works just fine because I'm in full duplex, but it did
surprise me the first time and I never saw the PTT drop on the repeater even
though I wasn't on the input of the repeater (COR wasn't active).

I'm not sure if this is from the RTCM, or the allstar server, or as a result
of the command mode.  I know it does not do this when the node is a half
duplex node 

Alan

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20120606/744f6d52/attachment.html>