[App_rpt-users] Quick question on usability

[Steve Agee]

Quick question on usabilityIf you don't already have it set this way, try 
changing the command to:

80 = status,11

N5ZUA

----- Original Message ----- 
From: Alan Adamson
To: App_rpt-users at ohnosec.org
Sent: Tuesday, May 29, 2012 12:06 PM
Subject: [App_rpt-users] Quick question on usability


I don't want to be a bad operator at the moment. As I go about checking 
bandwidth and jitter, etc on my setup. I'd like to connect to an active Hub, 
but just in eavesdrop mode.
But I've noticed that if I connect with the *2 command, that if I 
inadvertently then do a *80, that the ID goes out on the link that was 
connected with the *2.
Is this true anytime my node decides to ID?
Alan