[App_rpt-users] control of the tx tone

[Scott Weis]

Yes there is put:

itxctcss=1

in the node stanza.

-----Original Message-----
From: app_rpt-users-bounces at ohnosec.org
[mailto:app_rpt-users-bounces at ohnosec.org] On Behalf Of Pierre Martel
Sent: Friday, May 03, 2013 8:26 PM
To: Matt Roberts
Cc: APP RPT
Subject: Re: [App_rpt-users] control of the tx tone

Thanks matt,

This would work, but is there a way to make it permanent?

like in rpt.conf or such?


-----Message d'origine----- 
From: Matt Roberts
Sent: Friday, May 03, 2013 7:56 PM
To: Pierre Martel
Cc: APP RPT
Subject: Re: [App_rpt-users] control of the tx tone


On May 3, 2013, at 7:35 PM, Pierre Martel <petem001 at hotmail.com> wrote:

> All is working ok, but I have a few friend that use my repeater with some 
> cross band repeater radio. And they have difficulty cutting in cause they 
> have to wait after the tail and ct. before there cross band repeat radio 
> give them the chance to tx back at the repeater.
>
> On my old rc-210 we were able to stop encoding the ctcss tone while the 
> courtesy tone and tail of the repeater..So they were runnign ther xband 
> radio on tone squelch on rx and the tx on there side was fast and sharp.
>
> Is there  a way to do the same with app_rpt?

> Yes! Take a look at cop commands 58 and 59.

*  58 - Tx CTCSS On Input only Enable
*  59 - Tx CTCSS On Input only Disable

I have those commands defined so I can turn on and off using DTMF.


Matt Roberts
n9gmr at me.com
Call Sign N9GMR
Allstar 28142
EchoLink 640860

_______________________________________________
App_rpt-users mailing list
App_rpt-users at ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users