[App_rpt-users] Resistor divider

[Johnny Keeker]

I use the capacitor it good design practice to isolates the circuits 
although it will not strip the pl or dpl.  If I want to strip pl or dpl, 
use a Communication Specialists Board. You can try removes their 
audio cap and add jumpers.  "Just kidding".  Another consideration, 
take a look at, pin 16, connector P904, on the IF/Audio Squelch Board; 
RX PA. The audio is clean and de-emphasized. 
JK   


From: Robert Newberry <N1XBM at amsat.org>
To: Johnny Keeker <cypresstower at yahoo.com> 
Sent: Wednesday, October 30, 2013 8:08 PM
Subject: Re: [App_rpt-users] Resistor divider



I just realized that the DSP should be able to strip PL off. At least I think it can.
Apparare Scientior 
Paratus Communicare
-N1XBM
On Oct 30, 2013 6:44 PM, "Johnny Keeker" <cypresstower at yahoo.com> wrote:

Robert;
>You need to remove the sub audible tone when using vol hi, 
>but if your not concerned with hearing your ctcss tones,  
>use a 10uf cap off the vol hi through a series 10k to a 3.3k 
>to ground. Tap the audio where the 10k meets the 3.3k resistor.  
>Use a variable 5k pot in place of the 3.3k if you want to change 
>the levels or just change the 3.3k value.... 
>JK
>
>
>
>From: Robert Newberry <N1XBM at amsat.org>
>To: "app_rpt-users at ohnosec.org" <app_rpt-users at ohnosec.org> 
>Sent: Wednesday, October 30, 2013 12:45 PM
>Subject: [App_rpt-users] Resistor divider
>
>
>
>I need help, I am using a Mastr II and a URI. I want to use the vol/sql hi for my discriminator audio. I was going to use a resistor divider to pad down the audio. 
>Has anyone ever done this? Could you explain it in more detail to me. I've read you take the two resistors and put them in series. I would tap my URI in the middle where those two resistors meet. I assume one end goes to vol/sql hi, but where does the far end go?
>Thanks for your help
>Apparare Scientior 
>Paratus Communicare
>-N1XBM
>_______________________________________________
>App_rpt-users mailing list
>App_rpt-users at ohnosec.org
>http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20131030/e4cb6fbf/attachment.html>