[App_rpt-users] Odd CTCSS behavior on RTCM

[Chris Bunting]

Running version 1.41 .
Have 2 rtcms connected to mtr2000 , thunderbolt gps , pretty standard setup.
My simulcast is working great, however I can't get ct decode to work
properly. It's either in carrier mode or it doesn't work .

Odd things happen when I put what I assume is the correct settings in the
ct and for config on the rtcm. The rx light flashes and sometimes let's a
signal thru , but my repeater sorta goes flaky like the rtcm is pulling the
line down and flaking it out. The voltage pulsates on the CTCSS line and
the repeater receiver light goes out when it is actually receiving a
signal. Very odd .

Is 1.41 the best version? Any ideas what I'm doing wrong??
I'm using the rdstat2 pin on the MTR for CTCSS decode and it reads 5 volts
when receiving a valid pl .

Thanks in advance
N3FYI



-- 
Sent from My iPad
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20140609/817a9d5f/attachment.html>