[App_rpt-users] Echolink connection announcement Volume

[kk6ecm]

You've captured my interest. Our custom recordings are Allison replacements.

Thanks,
Bob
kk6ecm

Sent from my iPhone

> On Jan 5, 2016, at 7:29 AM, Pete M <petem001 at hotmail.com> wrote:
> 
> dont know if this is still up to date..
> 
> http://ohnosec.org/pipermail/app_rpt-users/2011-April/002592.html
> 
> 
> 
> -----Message d'origine----- From: kk6ecm
> Sent: Tuesday, January 5, 2016 9:59 AM
> To: mike at midnighteng.com
> Cc: app_rpt-users at ohnosec.org
> Subject: Re: [App_rpt-users] Echolink connection announcement Volume
> 
> The audio was setup using the prescribed method, without the "MK-1 calibrated ear." If we raised the rx oval, and reduced the tx level, then we'd have difficulty hearing the station id. I suspect the level of our custom recordings is too high, an I was trying to avoid the brute force method of redoing each one.
> 
> Thanks,
> Bob
> kk6ecm
> 
> Sent from iPad
> 
> 
>> On Jan 4, 2016, at 9:13 PM, mike at midnighteng.com wrote:
>> 
>> 
>> As far as I have known the answer is NO.
>> Your problem is from improper audio levels in everything else.
>> Your radio rx audio is probably weak "AND" the tx audio is probably high.
>> Raise rx and drop tx and it should level out.
>> I assume your using the 'technical ear scope' method. hihi
>> 
>> You can shut the announcements off.
>> But I would suggest getting the audio correct.
>> 
>> ...mike/kb8jnm
>>