[App_rpt-users] USB Audio Fobs

[Jon Rorke]

Hi Ramesh, you may be seeing the same issue I have with multiple URIs on 
the RPI.

this seems to be a problem when using USB radio on the RPI in the latest 
dial distro.

I reported it Steve N4IRS but don't know if its been fixed or not.

Perhaps you can do 2 RPI one per node for now.

Jon RQ

On 4/18/2017 10:22 AM, Ramesh Dhami wrote:
> Hi Guys:
>
> I am preparing a RPi3 to replace a dying PC with ACID at my repeater 
> site.  The Pi will control 2 full-duplex repeaters.
>
> I have prepared the config files at home and plugged in 2 (modified) 
> USB fobs.  Both fobs worked initially... i.e., I was able to connect a 
> test repeater to each fob and hear telem' data out of the repeater / 
> corresponding to the applicable node #.
>
> I am using usbradio for both fobs (config changed in modules.conf and 
> rpt.conf)
>
> The issue I have is that the LED on one of the fobs is no longer 
> flashing and hence, no audio out of that fob.  The LED is however, on 
> permanently.
>
> Here is the output of 'lsusb':
>
> Bus 001 Device 005: ID 0d8c:013c C-Media Electronics, Inc. CM108 Audio 
> Controller
> Bus 001 Device 004: ID 0d8c:000c C-Media Electronics, Inc. Audio Adapter
>
> It is the 2nd fob that seems to be non-responsive.
>
> Any ideas folks?
>
> I am reluctant to swap fobs between USB ports as I know that usb 
> enumeration can be a pig!
>
> Cheers,
>
> Ramesh, VA3UV
>
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at lists.allstarlink.org
> http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users
>
> To unsubscribe from this list please visit 
> http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users 
> and scroll down to the bottom of the page. Enter your email address 
> and press the "Unsubscribe or edit options button"
> You do not need a password to unsubscribe, you can do it via email 
> confirmation. If you have trouble unsubscribing, please send a message 
> to the list detailing the problem.