[App_rpt-users] remote base

[George Csahanin]

Mike, I have done all of the above fir my remote, a ft897 . But something is not right. When I try showvard fir the node I get a core dump, and asterisk exits. I just need to find a complete how-to on it. What is on the wiki is very thin on info. There used to be sample config files for a remote but can’t find it. 

If I comment out remote = ft897 and do showvars I get no dump. Is current DIAL for Pi able to do remotes? I have to dig, maybe I can find the computer I used fir a remote in 2010...

George Csahanin
Retired
Sent from my iPhone

> On Sep 5, 2018, at 11:58 PM, Mike <mm at midnighteng.com> wrote:
> 
> A file would be dependent on your particulars.
> But,
> It's just a node as any other, define your cor/ptt/pl logic & audio methods,
> and if is a freq agile remote, you may need to define port for tuning. See the wiki (i think it's in there) but some tune via serial and a DH-1 and some other though a parallel port definition. And define what kind of radio remote it is so it's tuning the right data instructions on that port.
> 
> A parallel port definition in rpt.conf
> iobase=0x378     ; Parallel port address
> or
> civaddr=72  ;(for ic-706)
> Radio:
> remote=ic706
> remote=rbi ; (doug hall rbi-1)
> 
> and last you need to specify that the node number is a remote base
> in rpt.conf node descriptions, with a 'Y'
> 1999 = radio at 127.0.0.1:4569/1999,Y
> 
> But it might help some if you state what kind of remote base you wish to set-up. It's not all the same. hope this helped.
> 
> ...mike/kb8jnm
> 
>> On 9/6/2018 12:35 AM, George Csahanin wrote:
>> Folks, I had a remote working back around 2010 using app_rpt. B ut I cannot find my documentation. I'm trying to lash it up again. But hit a brick wall on setting it up. Anybody have any config info that pertains specifically to remote.
>> I've googled it but it leads to pretty incomplete info on this...
>> GeorgeC W2DB
>> nodes 2360, 2428, 28599
>> ---
>> This email has been checked for viruses by AVG.
>> https://www.avg.com
>> _______________________________________________
>> App_rpt-users mailing list
>> App_rpt-users at lists.allstarlink.org
>> http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users
>> To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
>> You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.
>