[App_rpt-users] usbradio. conf

[Bryan Fields]

On 9/22/18 1:05 PM, Ryan Gross wrote:
> Group, Recent install of  listed build. Asterisk GIT Version adaec47 built
> by root @ odroidxu4 on a armv7l │ running Linux on 2018-03-07 14:53:41 UTC
> 
> 
> The problem I have ran into is when setting TX voice to 3.0 kHz I get a
> skipping of the tone. it goes away above 3.3 khc and below 2.9 kHz.  the RX
> appears to be normal across the nodes I have connected to and save as
> expected.

You're saying you don't have the adjustment range from the software tuning
values?  I've seen this before, and the solution was always to pad it
externally and get the adjustment in a more linear region of the set point.

It's why I prefer the RA-40 adapters, no need to set the deviation in software.

> 
> I am using the Repeater- builder original RIM and where I has in previous
> version Dial of ASL installed for Raspberry pi the PL tone worked.out of
> TXmixB.

Well perhaps Kevin can chime in, but I don't think there was much different in
his RIM.

> 
> Is something different ?


-- 
Bryan Fields

727-409-1194 - Voice
http://bryanfields.net