<div dir="ltr">Hi guys, <div>    I'm running a pair of UHF CDM1550's in full duplex with one of the new Repeater Builder Rim "lite" RM interfaces: </div><div><br></div><div><a href="http://www.repeater-builder.com/products/usb-rim-lite.html">http://www.repeater-builder.com/products/usb-rim-lite.html</a><br></div><div><br></div><div>It does not look like I can tap the GPIO's very easily on these boards, nor can I tell if GPIO 5-8 is available for general use looking at the schematic: </div><div><br></div><div><a href="http://www.repeater-builder.com/products/pdfs/RB_RIM_Max.pdf">http://www.repeater-builder.com/products/pdfs/RB_RIM_Max.pdf</a><br></div><div><br></div><div>What I'd like to do is drive a relay board to switch a fan on if the receiver is active or there is traffic coming in to the node, being connected to another station or hub for example. I read over the GPIO and event management subsystem documentation, and it looks like that's what I need, but I don't have a parallel port nor can I tap the GPIO's on my interface easily (or even know if they can be used as per the above). </div><div><br></div><div>Looking for ideas here if anyone else has encountered this, would prefer the logic/relay board approach vs. say a temperature controlled switch on the heatsink or something. </div><div><br></div><div>73</div><div>Stephen</div><div>K1LNX</div><div><br></div><div><br></div><div><br></div></div>