<div dir="ltr"><div class="gmail_extra">I'm running a Pi 3 too.</div><div class="gmail_extra"><br></div><div class="gmail_extra">Using <a href="http://vklink.com.au/">http://vklink.com.au/</a> as the image for local use in VK.</div><div class="gmail_extra"><br></div><div class="gmail_extra">I logged in shortly after I had a QSO on the repeater and the load average was 0.00, 0.01, 0.00. I also noticed while having another conversation on the repeater this morning, the problem started after 5-10 minutes or so, up to almost 7 syllables. Then the other user went clear for 5 mins, then came back and we continued the conversation with no delay for a further 10 minutes. </div><div class="gmail_extra">I've disabled the voter record function in the channel driver for now, just in case that is the issue.</div><div class="gmail_extra"><br></div><div class="gmail_extra">I guess I could try another RTCM/Voter unit sitting at the Master site with no radio attached at all purely for timing.  </div><div class="gmail_extra"><br></div><div class="gmail_extra">Sam - what did you change your buflen too?</div><div class="gmail_extra">My current config - </div><div class="gmail_extra"><br></div><div class="gmail_extra">buflen = 140 in voter.conf</div><div class="gmail_extra">Tx Buffer Length in RTCM's = 1120</div><div class="gmail_extra"><br></div><div class="gmail_extra">Ping to site 2 (slowest site) - Packets tx: 100, rx: 100, oos: 0, Avg.: 33.720 ms</div><div class="gmail_extra"><div class="gmail_extra"> Worst: 53 ms, Best: 32 ms, 100.0% Packets successfully received (0.0% loss)</div><div><br></div><div>Ping to site 1 (master site) - Packets tx: 100, rx: 100, oos: 0, Avg.: 3.450 ms</div><div>Worst: 4 ms, Best: 3 ms, 100.0% Packets successfully received (0.0% loss)</div></div><div class="gmail_extra"><br></div><div class="gmail_extra">Regards</div><div class="gmail_extra">Hayden VK7HH</div></div>