AMBEtest3.py without -n:pi@dmrlink:/srv/DMRGateway/DV3000 $ python AMBEtest3.py -s /dev/ttyUSB0Setting .../dev/ttyUSB0d8N1FalseFalseFalse
Reset6100010033Wrote: 5 bytes
Product ID6100010030Wrote: 5 bytes
Version6100010031Wrote: 5 bytes
Set DSTAR Mode61000c000a013007634000000000000048Wrote: 17 bytes
FTDI Driver:pi@dmrlink:/srv/DMRGateway/DV3000 $ less /proc/modules | grep ftdiftdi_sio 31072 0 - Live 0x7f11c000usbserial 22526 1 ftdi_sio, Live 0x7f10f000
Image:RAT_RC1
On Thu, Apr 6, 2017 at 9:38 AM, Steve Zingman <szingman@msgstor.com> wrote:
Did you try without the -n?______________________________
Are you on release candidate?
On 4/6/2017 12:37 PM, David KE6UPI wrote:
No Go
pi@dmrlink:/srv/DMRGateway/DV3000 $ python AMBEtest3.py -n -s /dev/ttyUSB0 Setting .../dev/ttyUSB0d8N1FalseFalseFalse
Reset6100010033Wrote: 5 bytes
Product ID6100010030Wrote: 5 bytes
Version6100010031Wrote: 5 bytes
Set DSTAR Mode61000c000a013007634000000000000048 Wrote: 17 bytes
------------------------------------------------------------ -----------
On Thu, Apr 6, 2017 at 9:04 AM, Steve Zingman <szingman@msgstor.com> wrote:
You could try following the draft document. Also pay attention to below.______________________________
I was having the same problem as you, since I own a first generation ThumbDV which runs at 230400 bauds.
When I removed the –n argument in the command: python AMBEtest3.py -n -s /dev/ttyUSB0, it then worked for me.
So for people with first generation ThumbDV’s, the command python AMBEtest3.py -s /dev/ttyUSB0 must be used.
Also, on page 3, Steve says at point 8: DO NOT edit DMRGateway.ini UNLESS your DV is not at /dev/ttyUSB0
If you run a first gen ThumbDV, the baud rate must be changed in it also to 230400.
And for Steve: thank you very much for all the efforts in the software and the documents. I went thru it all, and except for the items mentionned up here, everything went well and I’m ready for the next steps.
Thanks and 73s from Guy VE2VAG
On 4/6/2017 11:56 AM, David KE6UPI wrote:
Hello Steve, I haven't installed DMRGateway yet. You guys move too fast for me. Should I try and install to test it or hold off.
David
On Thu, Apr 6, 2017 at 6:03 AM, Steve Zingman <szingman@msgstor.com> wrote:
OK,______________________________
So Mike and I had a QSO from ASL <---> DMR Working in both directions without errors. This is on the current version of DMRlink and updated ambe_audio. This is on a c-Bridge. We are connected from the c-Bridge to BM on TS2 TG 3167.
I'm going to do some looking at logs. After that I'm going to move to a BM Master. That will be the ONLY change I'll make. If that works, The next step will be to add a second DMRLink connection to BM. Time will tell.
Steve
On 4/6/2017 8:48 AM, Robert Newberry wrote:
I didn't mind drawing a picture it was in my mind the easiest way to show my network...haha.
N1XBM
Apparare Scientor
Paratus Communicare
Allstar Node # 27086, 41540, 41812, 42086, 42658, 42657
www.radioguysrepeaternetwork.com
On Apr 6, 2017 8:41 AM, "Steve Zingman" <szingman@msgstor.com> wrote:
How do you think we feel, trying to understand you network before I can even begin to troubleshoot.______________________________
On 4/6/2017 8:39 AM, Robert Newberry wrote:
Wow, Steve and Mike I sure appreciate (and others I assume) your efforts. I was surely confused. It took me two days to fully wrap my arms around the issue to be able to formulate a semi coherent question and even then I still had to draw a picture!
N1XBM
Apparare Scientor
Paratus Communicare
Allstar Node # 27086, 41540, 41812, 42086, 42658, 42657
www.radioguysrepeaternetwork.com
On Apr 6, 2017 8:30 AM, "Steve Zingman" <szingman@msgstor.com> wrote:
We thing we are seeing the same issue with other DMRlink installs. As of right now, I don't know for sure where the bug is. I have my suspensions. We have moved testing from BM to a c-Bridge. The testing is with the current version of DMRlink and ambe_audio.______________________________
I do not think it's in ambe_audio since I'm seeing some of the same symptoms on DMRlink without ambe_audio. Since it APPEARS the bug is happening to existing "older" installs as well as the current version, I do not think the bug is in DMRlink.
Once we complete testing on c-Bridge, I'll move back to BM with the exact same configuration and see what we get. Software is fun!
73, Steve N4IRS
On 4/5/2017 3:50 PM, Robert Newberry wrote:
Steve,I'm not sure it will help, but I made a picture in PDF and e-mailed it direct to you.
On Wed, Apr 5, 2017 at 3:30 PM, Steve Zingman <szingman@msgstor.com> wrote:--
OK, So,______________________________
2 Masters, 1 Peer.
Peer connected to BM?
Repeater1 connected to Master1?
Repeater2 connected to Master2?
"2 masters then each repeater is peered to one master." ????
On 4/5/2017 3:24 PM, Robert Newberry wrote:
-No Actually 2 masters then each repeater is peered to one master. I had to do this because of NAT hairpining. I then have the Masters talking to each others to have both repeaters "linked"
-Yes I am Peered to BM.
- Yes my repeaters each have their own Masters withing DMRlink.
-No AMBE_AUDIO is peered directly to BM.
On Wed, Apr 5, 2017 at 3:13 PM, Steve Zingman <szingman@msgstor.com> wrote:--
I know you are running a bridge. Can I assume 1 Master and 1 Peer?______________________________
The Peer is connected to BM?
Your Repeaters connect to the Master?
The dmrlink / ambe_audio is connected to the Master?
On 4/5/2017 2:18 PM, Robert Newberry wrote:
Does anyone have any suggestions on how I should start troubleshooting this?I hope that I formulated my question in a way that makes sense. I am unsure how to trouble shoot this because it appears that DMRGateway works in both directions...sort of.This never used to work this way, If I TX'd on my DMR repeater it was heard on Allstar, and in the opposite if I TX'd on Allstar it would be heard on my DMR repeater locally.-When I TX on my local DMR repeater it is heard on BM by my test subject on an open spot, but the audio is not being heard on AllstarI've encountered a strange problem on my existing system that has been working for over a year without problem. I have not recently updated the software nor have I made any changes. The day I noticed it stopped working correctly I probably haven't even logged into it for weeks. I did all of the simple stuff like rebooting/ removing power to repeaters, routers, RPI's still hasn't fixed the problem.Here is the problem.
-When I TX on Allstar it goes up to BM and is heard by my test subject on his open spot, but the audio does not repeat on my local DMR repeater.
-When my test subject TX's on his open spot I hear it on Allstar and DMR.
--
N1XBM
Apparare Scientor
Paratus Communicare
Allstar Node # 27086, 41540, 41812, 42086, 42658, 42657
www.radioguysrepeaternetwork.com
_______________________________________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital _________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital N1XBM Apparare Scientor Paratus Communicare Allstar Node # 27086, 41540, 41812, 42086, 42658, 42657 www.radioguysrepeaternetwork.com _______________________________________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital _________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital N1XBM Apparare Scientor Paratus Communicare Allstar Node # 27086, 41540, 41812, 42086, 42658, 42657 www.radioguysrepeaternetwork.com _______________________________________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital _________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital _______________________________________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital _________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital _______________________________________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital _________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital _______________________________________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital _________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-di gital _______________________________________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar- digital _________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles. org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar- digital _______________________________________________ Allstar-Digital mailing list Allstar-Digital@lists.keekles.org http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-digital