; DMRGateway configuration file.
;   This file should be placed in either /etc or it can be
;   supplied as a path on the DMRGateway command line.

; General Section describes settings for DMRGateway itself.
;   For RPI, don't forget to modprobe snd_pcm_oss to get the devices populated
[GENERAL]
; Audio devices are normally not needed when in gateway service.  These devices should
; only be set when local monitor or dongle modes are required.
outputAudioDevice = /dev/null         ; Audio device /dev/null, /dev/dsp1, portaudio, etc
inputAudioDevice = /dev/null          ; Only used for dongle mode
decoderFallBack = false               ; Use software AMBE decoder

; Below values are for using this as a local DMR dongle (no ASL needed)
useMicrophone = false                 ; Use app as just a fancy dongle for DMR
useVox = false                         ; If using dongle mode (useMicrophone), enable vox
voxDecay = 2                          ; Hang time in seconds
voxTrigger = 200                      ; Value to trip ptt (0-32767)

; Information for ambe_audio.py
[AMBE_AUDIO]
server = 127.0.0.1                    ; IP address of DMRLink ambe_audio.py
fromDMRPort = 31000                   ; AMBE frames from DMRLink (should match "toGatewayPort" in ambe_audio.cfg)
toDMRPort = 31003                     ; AMBE frames to DMRLink (should match "fromGatewayPort" in ambe_audio.cfg)

; Information for USRP channel driver
;   This matches the rpt.conf ASL file with a setting like:
;   rxchannel = usrp/127.0.0.1:34001:32001
[USRP]
server = 192.168.168.10                    ; IP address of Allstar/Asterisk
toASLPort = 32001                     ; PCM from ASL
fromASLPort = 34001                   ; PCM to ASL
aslAudio = AUDIO_USE_AGC              ; Audio to ASL (AUDIO_UNITY, AUDIO_USE_AGC, AUDIO_USE_GAIN)
agcGain = -20                         ; Gain (in db) of the AGC filter
dmrAudio = AUDIO_USE_BPF              ; Audio from ASL (AUDIO_UNITY, AUDIO_GAIN, AUDIO_BPF)
dmrGain = 0.35                        ; Gain factor of audio from ASL (0.0-1.0)

;Information for DV3000 hardware decoder
;   Use top server and port if using AMBEServer
;   Use bottom server/port and serial = true if using the DV3000u (thumbdv)
[DV3000]
;server = 127.0.0.1                   ; IP address of AMBEServer
;port = 2460                          ; Port of AMBEServer
server = /dev/ttyUSB0                 ; Device of DV3000U on this machine
port = 460800                         ; Baud rate of the dongle
serial = true                         ; Use serial (DV3000U) or IP