On Saturday, January 30, 2016, Robert Newberry <N1XBM@amsat.org> wrote:

I was able to resolve the problem in /opt/dmrlink/ambe_audio/dmrlink.cfg I had to create a peer pointing back the master I have configured in /opt/dmrlink/bridge/dmrlink.cfg

I had to put the IP 192.168.X.X in the IP field using 0.0.0.0 or 127.0.0.1 would not allow things to work. Everything seems fine.

I was talking to a ham on analog he said the audio was a little hot. I noticed in the DMRGateway.ini there is a agc gain adjustment. Is this a OK adjustment to bring the audio down a bit?

I also noticed that if I key too quickly after someone is done talking on analog my transmission on DMR will not go out. I found waiting a few seconds, works fine. Would this have something to do with a hang time setting?

Other than that I can not find any other issues.

Thanks
Bob/N1XBM

On Sat, Jan 30, 2016 at 3:53 PM, Steve Zingman <szingman@msgstor.com> wrote:

Use netstat,to troubleshoot

Sent via smoke signal (AT&T 4G LTE)

-------- Original message --------
From: Robert Newberry <N1XBM@amsat.org>
Date: 01/30/2016 3:45 PM (GMT-05:00)
To: Steve Zingman <szingman@msgstor.com>
Subject: Re: [Allstar Digital] ambe_audio.py and bridge.py

Did you want to see what comes up with I type netstat? While I have bridge.py or ambe_audio.py?

On Sat, Jan 30, 2016 at 3:35 PM, Steve Zingman <szingman@msgstor.com> wrote:

netstat

Sent via smoke signal (AT&T 4G LTE)

-------- Original message --------
From: Robert Newberry <N1XBM@amsat.org>
Date: 01/30/2016 3:33 PM (GMT-05:00)
To: Digital linking using Asterisk and app_rpt <allstar-digital@lists.keekles.org>
Subject: Re: [Allstar Digital] ambe_audio.py and bridge.py

Well I thought I could instead in /opt/dmrlink/ambe_audio/dmrlink.cfg set it up to peer to my master I established in /opt/dmrlink/bridge/dmrlink.cfg

That doesn't work either. I obviously have to do something different.

On Sat, Jan 30, 2016 at 1:53 PM, Robert Newberry <N1XBM@amsat.org> wrote:
So I am working on getting everything to run at boot. I've been adding one process at a time to rc.local. So far so good, when I tried to add ambe_audio.py I got this error.

raise error.CannotListenError(self.interface, self.port, le)
twisted.internet.error.CannotListenError: Couldn't listen on 0.0.0.0:50001: [Errno 98] Address already in use.

So my repeater is a peer to dmrlink in /opt/dmrlink/bridge/dmrlinkcfg. I also set the same thing up in /opt/dmrlink/ambe_audio/dmrlink.cfg

This obviously does not work, so can anyone straighten me out?

_______________________________________________
Allstar-Digital mailing list
Allstar-Digital@lists.keekles.org
http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-digital