Steve,

It depends on how you want to operate your system.

The RTCM has a single connections for a receiver and transmitter, however they cannot work independently.

if you have planning on having your 2m and 6m repeater linked full time to each other then you can use 2 RTCM’s.

When someone keys up the 2m receiver it will also key up the 6m transmitter at that same site. As long as the 2 sites are linked then the audio will be transmit at the 2m and 6m site.

When someone keys up the 6m receiver it will also key up the 2m transmitter at the same site and the 6m transmitter at the remote site.

However if you would like to have the 2m and 6m repeater separate from each other you will need 4 RTCM’s. One for each transmitter and one for each receiver at each site.

Hope that helps.

Regards,

Chris Andrist, KC7WSU



On Feb 2, 2014, at 11:02 AM, Steve Wright <stevewrightnz@gmail.com> wrote:


RTCM's don't care what the frequency of operation is... just that one
transmits and one receives.

Pretty much like duplexers don't care what radios are connected to
them... nor does Asterisk care what equipment is on the other side of
the URIx ... COR/COS, Audio in, Audio out, PTT and Ground.

It's up to you to figure out which radio gets what connection ;-)

I'm pretty sure it doesn't care what antenna is connected either. 

But this doesn't answer my question.  Permit me to rephrase. Again.

Two split-site repeaters.  Each repeater receiver has its' corresponding transmitter on a geographically distant site (that's what a split site repeater is you know! ;)

The sites are linked with outdoor wireless ethernet 802.11an

Site "A"
6m TX
2m RX

Site "B"
6m RX
2m TX

Do I need two RTCMs or four?


Steve

_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.