Hi Keith
 
I have used an Icom F420 very successfully on Allstar for some time  The F510 is basically the same Radio
 
The pin 6 Horn drive output is the Carrier Detect (COR) line, Use the Mod in line for the Tx audio and the Det AF out for the RX audio
 
you will also need to jumper a solder pad inside the Radio to enable the TX audio form the Mod in line to the modulator in the Radio
 
All the best
73's
Bob
VK6ZGN
 

From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of keith
Sent: Saturday, 2 November 2013 1:11
To: app_rpt-users@ohnosec.org
Subject: [App_rpt-users] Icom F510

Evening all,

 

I have 5 x Icom F510 radio's and would be interested in getting this radio on my All-Star node. Has any station used this make and model on an All-Star node please.

I have purchased the 9 pin data feed but was not able to locate a COR line the following details is the pin assignments from this data port as listed below.

 

1. Do I need a COR / COS line or will the detail below be enough to install this PMR radio as my All-Star node? If at all possible an idea of the rpt.cfg to accommodate such a radio please?

 

The data out and in on this radio shows 1200 Baud.

 

 

 

 

Kind Regards

 

 

Keith Handscombe  G7DNT

 

 

No virus found in this message.
Checked by AVG - www.avg.com
Version: 2014.0.4158 / Virus Database: 3615/6782 - Release Date: 10/25/13