Ok, all updated to be as fresh as a very fresh thing after it’s been refreshed.

Still “Beep Beep Beep Beep Beep Beep”. Puzzling.

From: Tim Sawyer [mailto:tim.sawyer@me.com]
Sent: 07 August 2013 17:53
To: app_rpt-users@ohnosec.org list
Subject: Re: [App_rpt-users] Bleeping Hub

The latest code is not pulled during installation. Always update after a fresh install.

--
Tim
:wq

On Aug 7, 2013, at 7:42 AM, David Osborn <david.osborn@manx.net> wrote:

I have done this on many occasions but, now you mention it, I think that I haven't done it in this instance.

I must have thought that the latest was pulled down during installation - perhaps not.

Thanks for indulging a tinkerer :-)

From: Tim Sawyer
Sent: 07/08/2013 15:07
To: app_rpt-users@ohnosec.org Users
Subject: Re: [App_rpt-users] Bleeping Hub

Have you ever updated the source? https://allstarlink.org/support.html#astupgrade If not give it a try.

Tim

:wq

On Aug 6, 2013, at 11:11 PM, David and Rhianne Osborn <david.osborn@manx.net> wrote:

I omitted to clarify that this test was VMWare player and, to be honest, it does appear to sound and work OK, but I’ll heed the advice that it may misbehave.

If anyone could indulge my curiosity, though, where are these 6 beeps coming from? I disabled all CTs and also copied the rpt.conf from node 2483, which has run as a hub for a couple of years, and yet it still bleeps at me! If it’s relevant, the test hub has a private node address and doesn’t register with AllStar.

So, where’s the “beepy” bit? What’s it telling me?

Ta loads.

David

From: Jim W7RY [mailto:w7ry@centurytel.net]
Sent: 07 August 2013 05:26
To: Tim Sawyer; David Osborn
Cc: app_rpt-users@ohnosec.org
Subject: Re: [App_rpt-users] Bleeping Hub

A node on VM Player works perfectly on a Windows 7 laptop. I have a node running on this Windows laptop.

Why doesn't it work in VMWare?

Jim W7RY

From: Tim Sawyer

Sent: Tuesday, August 06, 2013 2:10 PM

To: David Osborn

Cc: app_rpt-users@ohnosec.org

Subject: Re: [App_rpt-users] Bleeping Hub

Running asterisk on a VM is a no, no... it's not supported... it doesn't work... forget it...

--
Tim
:wq

On Aug 6, 2013, at 12:30 PM, David Osborn <david.osborn@manx.net> wrote:

Hey gang,

Just goofing around, I wanted to see how well Allstar would play when configured as a hub node under VMWare.

Well, it worked and I was able to make connections to other nodes, connect with IaxRPT and all that good stuff. The thing is, it likes to beep.

When I connect the virtual hub to another node and then key that node, when I let go the button I get 6 rapid beeps followed by the courtesy beep from the node I’m accessing.

I believe that these beeps are coming from the V-Hub, but can’t figure out why.

Anyone got any ideas on this one?

Thanks

David – GD4HOZ

_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users