Hi Guys,

My modified CM108 suffered a catastrophic failure yesterday (one of the 3.5mm jacks broke off the board), and for the time being I've had to resort to parallell port PTT switching.

It works fine - But I have an issue where when I start the node up, the PTT is being held open until such a time as the node sends a CW ID, and then it will drop after the ID.

This is far from ideal, as the TX can be held open for up to 15 minutes at a time!

Is there a known fix for this? or can I setup a cron/scheduler event to send a one off CWID, say 10 seconds after initialisation to make the PTT drop?

If the answer is yes, then how do I do it?

Thanks,

James - 29681