If you’re not on the gateway node then yes, you have to do the *4xxxx “by your command” bit. You could set that up as a macro. For example if 1000 will be the private node and 2000 the public.

[macro]

1 = *31000*41000*32000#

now *51 will connect to the public node.

You could put the IP address of the gateway in each of your private nodes (and visa versa) which would save the whole *4 thing to connect to the gateway. But you’d still need to do *4 to connect the public node to other public nodes.

--
Tim
:wq

On Nov 7, 2014, at 6:59 AM, Sam Nabkey <sam.nabkey@gmail.com> wrote:

Can you share how you would configure the private modes to use the public as a gateway?
I am doing something similar but I command the public node to connect to another public using the *4 commands. .
Do you know of a direct way?