Your replies are fine.

Setting levels with a HT on usbradio might be a little iffy. Be that as it may here is the procedure to "tighten up" the DTMF decoder.

1: shut down asterisk
2: cd /usr/src/astsrc-1.4.23-pre/asterisk/
3: edit line 10 of menuselect.makeopts
4: change MENUSELECT_CFLAGS=RADIO_RELAX LOADABLE_MODULES
5: to MENUSELECT_CFLAGS=LOADABLE_MODULES
6: save
7: make
8: get coffee
9: make install
10 restart asterisk

Please let me know if this helps.

73, Steve N4IRS

On 3/16/2017 2:40 PM, William Higgins wrote:
I haven't figured out how to do replies when I only get the digest in gmail.

Anyway, Steve, re this:

>I don't THINK the receiver dropout and the EchoLink inbound are related.
>The problem COULD be radio_relax. (The DTMF decoder is falseing) Though
>I wonder about the duration of the dropout. How did you set receive levels?
>
>Steve

I was monitoring the Asterisk console this morning during a QSO on the repeater and DID see a number of DTMF false messages.  They were all just a matter of 10-100 milliseconds, but there did seem to be a disruption of the audio when they came along.  I didn't tie the two together in my head because there didn't seem to be a one to one correlation, if you get my drift.

I set the receive levels using radio-tune-menu.  It was all done onsite at the repeater with MINIMAL equipment (an HT.)  I have since done some tuning on it (especially the receive levels) from home during typical QSOs.

Bill


_______________________________________________
App_rpt-users mailing list
App_rpt-users@lists.allstarlink.org
http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.