I run quite a few Limey nodes. I have had this happen and it seems if
you
wait 10-20 minutes it starts working. I think the node has to register
first.
Also make sure the last thing that shows up on the monitor is ztttanscode
loaded.
It will not work until you see that.
Lee
2233
In a message dated 7/14/2013 6:48:37 A.M. Pacific Daylight Time,
jrh@g0fhm.co.uk writes:
On
14/07/2013 13:15, James Hill wrot
>>
>
> Hi
Jim,
>
> Righto - it's a case of old habits die hard.... I've
always used
> chan_usbradio on more powerful hardware. I'll reinstall
Limey on
> another CF card, and this time set up for
simpleusb.
>
> Cheers,
>
> James
Hi
Guys,
I give up!
No matter what I do, Limey seems to think that
my CM108 device is "Not
active". If I run lsusb it shows as there. Running
simpleusb-tune-menu
it shows it as there and selectable, but when I try to
change a
parameter it just says it's not active. I tried a fresh install
on a
different CF card for simpleusb. Same thing!
If I plug a 2.5"
HDD into the thin client running ACiD, everything works
fine!
I'm
confused!
J
29681
_______________________________________________
App_rpt-users
mailing
list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users