Check the ports being forwarded to your node. 

From: http://www.echolink.org/firewall_solutions.htm


EchoLink requires that your router or firewall allow inbound and outbound UDP to ports 5198 and 5199, and outbound TCP to port 5200.  If you are using a home-network router, you will also need to configure the router to "forward" UDP ports 5198 and 5199 to the PC on which EchoLink is running.
This can be summarized as:

Allow UDP destination ports 5198-5199 between Internet and PC in both directions
Allow TCP (source port any, destination port 5200) from PC to Internet"


If you don't have the ports 5198 and 5199 forwarding UDP packets to the node, you won't receive any incoming Echolink connections.


73
Stacy
KG7QIN


On 01/03/2016 03:36 PM, mike@midnighteng.com wrote:
Outside the obvious...
..One connection per Internet IP

..Proper port forwarding for udp 5198 & 5199 (if you are on a dhcp, your ip may
have changed)

..changing echolink servers in set-up

I wouldn't have a clue ;)

...mike/kb8jnm


Just setup a new node (42928) using DIAL on a RPi which is registering on
both the Allstar and Echolink (518309) sites, showing up as valid on all
lists. The repeater works fine with radio calls, and incoming Allstarlink
node connections, but not from Echolink. CLI> indicates successful reception
from the Echolink servers... no errors or warnings of any type in CLI>. The
node just does not see any incoming contacts from Echolink. Any ideas?

By the way, simpleusb has way too much audio delay... hear whole words after
unkeying. Whereas it's not as noticable using usbradio.

Thanks,
Bob
kk6ecm

_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the
bottom of the page. Enter your email address and press the "Unsubscribe or edit
options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If
you have trouble unsubscribing, please send a message to the list detailing the
problem.



_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.