What type of radio are you using for the node radio? And what interface?
(EX: Kenwood V71A to a URI through the data port)
Just went through this with a another node one on one. The problem found
was that the Kenwood V71A uses speaker audio not flat audio for the data
port.
Icom and Kenwood would decode but Yeasu DTMF was not recognized.
On this same node I changed his status,1 and status,2 announcements to 11
and 12. Now the announcments do not play. If I issue rpt localplay nothing is
generated over the rf side.
If I issue playback from the cli it plays the script local not
global. Any ideas?
Brian
KB3ORS
Sent: Friday, January 21, 2011 1:31 AM
Subject: [App_rpt-users] DTMF decoding
Hello group,
I have another question.. I've just switched to
Allstar from EchoIRLP, and am having trouble with the software dtmf decoder. All
of my radios could command the EchoIRLP system, using the hardware DTMF decoder,
but I'm having an issue with 2 radios on app_rpt and the software
decoder.
Two rows of DTMF buttons are not decoding on 2
radios. On a few other radios, all buttons decode correctly.
My node radios are the same, and my mobile and HT
are also the same.
Is there a twist setting or other possible setting
I could try changing? I would be elated if the hardware DTMF decoder were
supported, but I am pretty sure it's not supported in app_rpt.
Thanks. 73.
Kyle
K0KN
_______________________________________________
App_rpt-users mailing
list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
No virus found in this
message.
Checked by AVG - www.avg.com
Version: 10.0.1191 / Virus
Database: 1435/3392 - Release Date: 01/20/11