Hello All,

I am wanting to configure my node to have two PL tones where when one is used for local communications and the other goes out the link.  I know some people were able to get it working and I was wondering if I can get some help.  I remember that I could add the other PL tones separated by a comma.  >From what I understood, the first PL will send the audio out the link and the remaining PLs will be local.

My Config:
--running DIAL on a small form factor pc. 
----using USBRadio
----DSP carrier and PL decode
--Repeater is a Kenwood TKR-850 and configured with an open squelch to AllStar, no PL decode or encode.

In my usbradio.conf

txctcssdefault=100.0
rxctcssfreqs=100.0,88.5
txctcssfreqs=100.0,88.5

When I key up on either PL, the audio goes out the link.

Can anyone verify this?  Are there any other config changes that need to be made?

Thanks

Sincerely,

boB - W5EVH