Pin 23-24 is correct. This has been
updated on the website, as you've indicated, and told it is updated in newer
uridiag.
Thanks,
Bob
kk6ecm
From:
app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of John C. Westmoreland, P.E.
Sent: Thursday, August 13, 2015
10:52 PM
To: app_rpt mailing list
Subject: Re: [App_rpt-users]
Correct Wiring For The URIx Diagnostic Dongle
Hello Again,
To get correct results - doesn't it make more sense to wire up this:
From the above - how does AIN (pin 24) work?
73's,
John
AJ6BC
On Wed, Aug 12, 2015 at 10:39 PM, John C. Westmoreland, P.E. <john@westmorelandengineering.com>
wrote:
Hello All,
Here is the wiring instructions from the FAQ:
Pin 1 to Pin 7
Pin 2 to Pin 3
Pin 4 to Pin 8
Pin 23 to Pin 24
10K Resistor between Pins 21 and 22
10K Resistor between Pins 21 and 23
For URIx (CM119) only, also include the following connections:
Pin 5 to Pin 10
Pin 6 to Pin 11
From uridiag:
Enter your selection:c
Special Test Cable Pinout:
25 pin D-shell connector
Pin 1 to Pin 7
Pin 2 to Pin 3
Pin 4 to Pin 8
Pin 11 to Pin 24
10K Resistor between Pins 21 & 22
10K Resistor between Pins 21 & 23
For URIx (CM119), also include the following:
Pin 5 to Pin 10
Pin 6 to Pin 11
Do *NOT* include these for the standard URI!!
So, which one of these do I use?
73's,
John
AJ6BC