Have you tried increasing the squelch level? What is the current squelch level?
Corey N3FE
From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Bill Hurlock
Sent: Thursday, October 03, 2013 7:46 PM
To: app_rpt-users@ohnosec.org
Subject: [App_rpt-users] Long Squelch tail problem
I had to go back to my URI interface and my FT-736R. I have it set up to do tone encode and decode using the URI. All the encode and decode are working however when I unkey there is a squelch tail that lasts about 1 to 2 seconds. I’m allowing the URI to determine COR thru DSP. The connections are setup for raw audio both ways with the node supplying the pre and de emphasis. I have played with the settings but nothing changes the problem. It isn’t a consistent duration of tail. I know it is in tone decode mode because if I turn tone off on the portable I can’t open the squelch thru the node. Anyone have any ideas……
Bill Hurlock
CPCommunications
856-234-1661 Office
856-264-1010 Cell
WA2TQI
--
This message was scanned and is believed to be clean.
Click here to report this message as spam.