Hello all.
I have 2 Nodes here an RTCM on node 28467 and a Beagle xM/LOX
combo on node 29701
The RTCM works real well, no problems at all, but, the Beagle
xM on the other hand has a one little issue I can’t seem to fix, can’t been seen
in the database.
Reading the mail on this list the past few weeks and this same
issue has already been raised, I see that I cannot have 2 different Nodes with
the same port ( 4569 ) running on the same IP, they have to have unique port
numbers.
To that end I have left the RTCM on port 4569 but I have moved
the Beagle xM to port 4568.
Having done that to the Beagle xM I went in to the iax.conf
and changed the bindport there, then I went in to allstarlink.org and changed
the port number there too and submitted the changes. The Beagle xM now works
fairly well, I can make outgoing calls AND it can receive incoming calls also
but the Beagle xM ( node 29701 ) is not seen to everyone, no longer in the
database.
The router I use here at home is a Netgear DGND3700 and it
doesn’t seem to allow the Beagle to be registered in the database, but when I
test the Beagle on another router I have, a TP link 3G the Beagle is seen by
everyone and it looks like it is in the database.
I believe there are a few routers that do give a bit of
trouble, and the Admins can do something to help get Nodes registered so I think
I am in need of their help at this point, if no-one else has any other
suggestions.
Thanks guys.
Ron.
VK3ANT
Melbourne.