Alan... You miss understand...

I WANT the RTCM to generate my PL so I can use chicken burst on my non Motorola branded radios. I DON’T like squelch bursts Smile

As for your COS issue... Don’t use COS. Let the RTCM handle it. Just put discriminator audio into the RTCM. Also let the RTCM decode your PL tone too. It it’s as good as the URI, you have no worries!

My plan is to us a pair of GP-300s (P110s) to make a repeater using the RTCM as a repeater controller.

Jim W7RY

From: Alan Adamson

Sent: Monday, June 18, 2012 12:07 PM

To: 'Jim W7RY'

Subject: RE: [App_rpt-users] RTCM CTCSS Output Tone

Jim, when you get done, you have *got* to share :)…

Can't you just program the GP300 to TX with the PL tone and not worry about the PL from the RTCM? Is the issue that you are not going into the modulator, you are going into the mic input, so the PL gets whacked or distorted?

I run an RTCM on my repeater, but I let the repeater TX do the PL encode, I just put audio into it from the RTCM

Alan

From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Jim W7RY
Sent: Monday, June 18, 2012 3:03 PM
To: app_rpt-users@ohnosec.org
Subject: [App_rpt-users] RTCM CTCSS Output Tone

Just received my RTCM! Whoo Hoo! Have a question though.

The PL tone output is also the transmit audio output. With my USB fob, I used both channels of the TX out, one for PL and one for audio. This worked perfectly for a Motorola Mitrek. Now I will be using a GP300 or P110 for a transmitter and would really like to separate the PL tone output from the audio output.

What have others done? Will a 16 pin GM300 take PL into the microphone input?

Or are you running the RTCM transmit audio into the flat audio input of the radio? Does the radio provide deviation limiting with this setup? I don’t think it does.

Thanks!

Jim W7RY