run lsusb at the command line, then set devstr=<bus>-<device> for the device(s) shown. Your example is for Bus 004 Device 002.

Bob

kk6ecm

From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Steve Agee
Sent: Saturday, May 21, 2016 12:05 PM
To: app_rpt-users@ohnosec.org
Subject: [App_rpt-users] usbradio_tune_xxxxx.conf where .conf = .confusion

Hello list:

I've searched

<http://www.xelatec.com/xipar/node/180>

and I fully understand the description/explanations given. What I don't understand, with specific attention to the lines:

; name=usb ;
; devnum=1 ;
devstr=4-2 ;

is how to manually uncomment, and manipulate them. In this particular instance, I'm trying to get a DIAL box running with one original URI (early version) using the USBRADIO channel driver, and one URIX (newer version) using the SIMPLEUSB channel driver. I've followed the step-by-step (or was that Crossbar 5 Duude?) instructions for starting off with a single node, then adding the second node. That simply doesn't work. The second URIx green L.E.D. stays solid throughout the process. Are these lines provided for informational purposes only, or can they be edited to force the second device to be recognized and assigned?

N5ZUA