Hello all...

I have been working on an agile remote base using an Icom 706.  I have seen a lot of posts and read a lot of ideas on using this radio.

I first attemped using this under the Beagle Bone but I didn't have any luck.  SO I switched to an ACID install that was previously working as a Repeater Node.

I first added the remote stuff back to the rpt.conf - and the symptom returned.

The only working config has the line 'remote = ic706' commented out.

Anyone have any ideas on why the USB interface won't start, or the node would die just because the remote statement was added?

I could use some pointers?

--

Samuel T. Nabkey - K8SN