Sure, the two site system I have on the air now works very well. I modified the transmitters to modulate the VCO directly and by luck their frequency response across the audio spectrum happened to be identical. When I went to add a thrid transmitter to this system using an identical model unit I found the frequency response slightly different causing the PL tone audio to be a bit hotter than the rest of the transmitters when i adjust it for 1000 Hz @ 3 KHZ deviation. Its perfectly usable but you can notice the growl of the PL at times due to the level not being within where it needs to. So that's the whole story and why I am going this route. If this works they way i think its going to, I will post the results and the schematic, parts list and gerber files for the board.

On Tue, Jul 11, 2017 at 4:16 PM, Bryan Fields <Bryan@bryanfields.net> wrote:

On 7/11/17 4:12 PM, Joe Moskalski wrote:
> I will be separating the voice audio and PL audio using active filters so that
> I can inject the PL tone and Transmit audio to separate points on the
> transmitter so that the Transmit audio and PL tone level can be adjusted
> independently at each transmitter in the simulcast system. Unfortunately this
> transmitter adds preemphasis to the transmit audio and this cannot be changed
> in the transmitter.

You certainly understand it then, and sound like it's under control. Lots of
simulcast questions don't quite have the same level of detail understanding.

Easiest way is to change the code or do an external filter. Since you're
building a board anyways, an external filter would probably be the easy way to
do it.

I'd (and I'm sure others) be interested in the details of your system when you
get it working.

73's

--
Bryan Fields

727-409-1194 - Voice
http://bryanfields.net
_______________________________________________
App_rpt-users mailing list
App_rpt-users@lists.allstarlink.org
http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.