simpleusb does not do PL deocde. You need to use the COS line. If one is not available in your receiver based on PL then you could use an external PL decode board that would give you an output level change. Many radios have a data or accessory port that has the level change on signal pin available.

Not sure what might be wrong with the echolink but you kind of answered your own question when you said one was working and the other not. Are the config files the same? The config file is the only setup.

You do know that you can only have one echolink per public IP right? You can only have one local IP address port forwarded with the echolink ports. This is true even though you can have three echolink addresses - your call, your call-l, and your call-r. Only one can be used at a time unless you have multiple public IP's or you use proxies. So you can't have an iphone using your wifi and echolink on your RPi2 simultaneously.

73 Doug
WA3DSP
http://www.crompton.com/hamradio

Date: Mon, 27 Jul 2015 00:56:44 +0000
From: kd8usf@yahoo.com
To: app_rpt-users@ohnosec.org
Subject: [App_rpt-users] PL decode

OK guys a couple questions, first can I do PL decode in rpt with the simple usb interface? How is that configured? Or can someone send me a sample config?

Second is, using the created config files for asterisk in the initial install of the RB Pi2 image from hamvoip, everything is working except the echolink side. It's like it's stuck in monitor mode or something, it connects, you can hear the activity from the allstar side coming out on the echolink system, but we can not TX back into allstar. I cannot figure that one out. I have a second Pi2 setup with allstar and echolink also but it works fine, I dumped the original config files off my old system on that one, so it's something i'm apparently missing in the config that I cannot seem to find.

Thanks, Andrew.

_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.