Steve,
Be aware that those transmitters are dirty.
There is a note about a module using the same RF
circuit on Doug's HAMVIOP site.
He suggests a filter. REQUIRED if you are going to
drive a amp or even connect it to a antenna!
73, Steve N4IRS
On
10/6/2015 9:13 AM, Steven Donegan wrote:
Thanks.
For my first full duplex repeater (for
test/learning purposes) I am going with 2 of
those modules and a 6 cavity duplexor (likely
of the 'notch' variety). If it works out may
put my Mirage BD-35 on the TX side before the
duplexor and get ~16 watts for giggles.
Steven
Donegan
KK6IVC General Class FCC License
Silver State Car #86
www.sscc.us
I'll send you the info tonight when I
get home. I have a couple of them.
On 10/6/2015 9:10 AM,
Steven Donegan wrote:
Thanks
Steve! I'll look into that as
well.
Steven Donegan
KK6IVC General Class FCC
License
Silver State Car #86
www.sscc.us
Steve COR or actually
RUS "Receiver Un
Squelch" is available
in that radio. You
have to unsolder the
shield to get to it.
73, Steve
On 10/6/2015 8:56 AM,
Steven Donegan
wrote:
Steven Donegan
KK6IVC General
Class FCC
License
Silver State
Car #86
www.sscc.us
That
might work, I
use it for
packet.
What
radio are you
on?
Sent from my
iPhone
Does anyone have a
circuit that
will take
audio from a
radio and
generate a
pseudo COR
signal for the
URI-x? If so
would you
share the
circuit
diagram?
TIA
Steven
Donegan
KK6IVC General
Class FCC
License
Silver State
Car #86
www.sscc.us
_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.