I have a XIPAR node that needs a little support with pulseback removal. Never had to utilize this before, but when looking in URD.conf, I don’t see the rxdelay= parameter like I do on ACID builds. I went ahead and inserted the command into the file, but there does not seem to be any action.
Can someone confirm the parameter and placement?
Here is my example:
[usb]
hdwtype=0 ; 0=std,1=dev
eeprom=0 ; unless you have a cable w/eeprom
duplex=0 ; 0=simplex, 1=duplex
invertptt=0
;minsigproc=0 ; minimal signal processing
;sendvoter=0 ; 0=default, no voter rssi, 1=enable voter rssi
carrierfrom=usbinvert ; no,usb,usbinvert,dsp,vox
ctcssfrom=no ; no,usb,dsp
rxondelay=3000 ; Gets rid of the pulseback problem
;rxboost=1 ; rx input boost of 20dB
rxboost=0 ; no boost
rxdemod=flat ; no,speaker,flat
txprelim=0 ; 1 = pre-emphasize and limit
txmixa=voice ; no,voice,tone,composite
txmixb=tone ; no,voice,tone,composite,auxvoice
;txctcssdefault=77.0
;rxctcssfreqs=77.0;
;txctcssfreqs=77.0;
txtoctype=notone;
rxsquelchdelay=900 ; delayline in ms carrier squelch tail eliminator
rxnoisefiltype=0 ; 0 for +/-5KHz, 2 for +/-2.5KHz systems
Lu,
KA4EPS