set the bootloader IP to be the same as the voter board IP, or make it different than anything else on the network.  It is the IP that the voter board uses when it is running the bootloader code.  It can not have the same IP as your laptop.  That will not work.

On Sat, Nov 15, 2014 at 12:10 AM, Corey <kc7mrq@bresnan.net> wrote:

I built a through hole voter board and interfaced it to a GPS 18 LVC and my server. I set the board up as a master, transmit. The LED shows the GPS locked and 98 command shows the GPS,
but I am getting the following error when telnetting into the board:

Warning: GPS Data time period elapsed.

The error is timestamped and occurs every second. I made sure the data format was NMEA per archived messages on here by connecting the GPS to SNSRCFG. The config appears to be set up correctly.
What other areas do I need to look at to fix this warning?

I did notice you can choose quite a few NMEA messages in the SNSRCFG profile. Does it matter if all are checked?

I have a second issue with updating the firmware. The board is at Rev 1.41. I tried updating it, but haven't had any luck so far. Nothing happens when I click on the "capture target" button after resetting the voter board. The target ip is the voter board and the bootloader ip in the voter is my laptop with ENC_Loader.

 The IC(s) were originally programmed by a friend in another state so I never experienced what it take to do the initial programming.


Thanks for your help,
Corey
_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.