Hello everyone,

I have finally got the ic-706 remote base partially working

I can scan freq, move up in freq, and read status, Now that the commands 

also the init=freq..... works when I connect so it can set the frequency.

just fine, yet if I do *1444*000*0... etc does not work

If I do *0001 for memory 001 etc, I get 'memory not found'

which the memory is in the rpt.conf

[memory]

  ;Syntax : CC=RRR.RRR,PPP.P,AAAAA

  ;          C=Channel Number

  ;          R=RX Frequency

  ;          P=PL Frequency

  ;          A=Attributes

  ;

  ;Attributes : a=AM   b=LSB  f=FM  u=USB

  ;             l=Low Power   m=Medium Power   h=High Power

  ;             -=Minus TX Offset    s=Simplex     +=Plus TX Offset

  ;             t=TX PL on    r=RX PL on

  ;

004=147.700,123.0,fshrt

005=147.100,123.0,fshtt

006=003.860,100.0,bshrt

init=003.980,100.0,bshrt ;Set to this on startup

This is just above the macro section below the functions-remote...

At the end of the file I tried[memory]

[memory]

001=147.700,123.0,fshrt

002=147.100,123.0,fshtt

003=003.860,100.0,bshrt

None of these work, always says 'memory not found'

Any ideas? I know I am getting close to making this work!

0=remote,1                             ; Retrieve Memory

1=remote,2

Mark KC7DMF 

App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users