No diagram,
You can get your cor from the csq/tsq open LED.

I might suggest using a old brick HT (ic2at etc) in place of those Chinese HT's because the rx sensitivity is twice as good.And near  freq signal rejection is much better. I know... using what you have... but it is well worth it if you can use the older gear. They are cheap also.

Guessing you are making a portable system as I would ditto/echo the warning on long term use of a HT on a repeater tx. Even at low power.


...mike/kb8jnm

-------- Original Message --------
Subject: Re: [App_rpt-users] Does anyone have a working circuit diagram
for Baofeng/Kenwood to URIx?
From: "Scott Weis" <kb2ear@kb2ear.net>
Date: Wed, June 11, 2014 3:40 pm
To: "'Steven Donegan'" <steve@donegan.org>, "'&#39;App RPT Users&#39;'"
<app_rpt-users@ohnosec.org>

I doubt you will find much help anywhere. Baofeng radios lack COR and discriminator output so they would not be suitable for use with allstar. The only portable I know of that works is the Kenwood F6 with it mic/speaker port set for packet mode. But the duty cycle required for allstar or any repeater/remote base is fairly high and portables are not suitable for long term use.
 
From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Steven Donegan
Sent: Wednesday, June 11, 2014 3:21 PM
To: 'App RPT Users'
Subject: [App_rpt-users] Does anyone have a working circuit diagram for Baofeng/Kenwood to URIx?
 
I am looking for a circuit diagram so I can fabricate a cable to connect a URIx to a Baofeng (or pair of Baofeng's) suitable for use with ACID/Allstar. Any assistance would be useful. I have not found anything on the web thus far...
 
____________
Steven Donegan
KK6IVC
SSCC/NORC Life Member, Car #86
www.sscc.us
_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.