Thanks Steve, I'll play with these settings. I initially tried 3K as a cutoff but still hear the "artifacts" noise that comes with Allison announcing things (that's how I test quietly). It reminds me of how P25 sounds on the fringe, so its likely something in the conversion to MP3 from RAW or GSM.

I guess for streaming, we don't need a range like what a radio would provide (say 300-3000hz), but perhaps something narrower.

To answer Bote as well, I'm using these standard settings for Lame, and most changes from say 8K to 22.05K make it sound like Chipmunks got into the system. I'm still learning the settings.

I still need to figure out how to get the stream to work at the base URL, not requiring a filename. 

Tony


--- On Fri, 9/23/11, Steve Passmore <k6kya@hokeynet.net> wrote:

From: Steve Passmore <k6kya@hokeynet.net>
Subject: Re: [App_rpt-users] Streaming questions
To: app_rpt-users@ohnosec.org
Date: Friday, September 23, 2011, 12:03 AM

Got my Highs and Lows swapped...   oops

On 9/22/2011 22:00, Steve Passmore wrote:
I don't believe wav is a stream-able protocol.  The metallic sound is more an artifact of compression than the protocol used.   You might try bumping up the bitrate and/or adding a lowpass filter to strip off the highest  frequencies,  this is commonly done with stream encoders.  I've added a highpass filter to remove PL.  I imagine you could do low pass the same way.   Here's what I use.

outstreamcmd=/bin/sh,-c,/usr/bin/lame --preset cbr 24 --highpass 0.2 -r -m m -s 8 --bitwidth 16 - -  | /usr/bin/ezstream -c /etc/ezstream.xml

Steve


-----Inline Attachment Follows-----

_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users