W3882F8780314544B8F9040BA420@phx.gbl>
Content-Type: text/plain; charset="iso-8859-1"
Mike,
When you do this you should have the client open and watch the log. Much info can be gained there.
73 Doug
WA3DSP
http://www.crompton.com/hamradio
Date: Sun, 11 Jan 2015 10:53:33 -0500
From:
mike.lussier@gmail.com
To:
app_rpt-users@ohnosec.org
Subject: [App_rpt-users] what am I missing ?
I stepped away from this last night. I was getting frustrated.
What I'm trying to do. dial via DTMF from radio and route the call to
the local PBX in my home. I already have a Trunk established between the
PBX and the
BBB Node. I can place calls directly to the node, TX & RX.
When I
initiate a call to the phone from my HT the only response I get back is a courtesy
tone.
I have tried all of these combinations.
*6 6001 #
*6 6001
6 6001 #
6 6001
There is an IAX2 trunk from the PBX to the BBB AllStar node running 1.2.1.
I can place a call to the node from the phone. I can transmit & receive.
on the BBB node :
I setup my test phone extension 6001 in iax.cnf file on the node the dial command is different dial=iax/6001
[6001]
deny=
0.0.0.0/0.0.0.0
username=6001
secret=xxxx
dtmfmode=rfc2833
canreinvite=no
context=radio-control
host=dynamic
trustrpid=yes
sendrpid=no
type=peer
nat=no
port=5060
qualify=yes
qualifyfreq=60
transport=udp
encryption=no
callgroup=RPT
pickupgroup=ALL
dial=IAX6001
permit=
0.0.0.0/0.0.0.0
allow=ulaw,gsm,h263
=======
rpt.conf
6=autopatchup,noct=1,farenddisconnect=1,dialtime=40000 ; Autopatch
up
=======
In extensions.conf the phone patch is the [RADIO] context
[radio]
exten => _5XXX,1,Dial(iax/${EXTEN},17); ; home phones
exten => _6XXX,1,Dial(iax/${EXTEN},17); ; mesh phones