My mistake, as I found I had calibrated the squelch with the squelch pot at 600+(doing a 98status) and found that with the squelch pot all the way down first then, the squelch calibrates at 92 and when turned up to 400+ starts working much better ...it is just that when using a URI the very same people/signal had no tail at all, prob only way back to that with an RTCM is with a micor squelch chip

Jim Frederick KF6QBW
446.600- 100.0 PL Repeater
AllStar Node # 28839

Skype = jim41.2

On Tue, Jan 28, 2014 at 1:30 AM, Chuck Henderson <rpt2@chuck.midlandsnetworking.com> wrote:

Have you updated your RTCM to the latest firmware from SVN? Are you setup to compile your own firmware?

On Mon, Jan 27, 2014 at 8:43 PM, 41.2 Jim <41.2jim@gmail.com> wrote:

Question.... is their anything that is universal to both Stanzas, "usbradio.conf & voter.conf" that can be used with an RTCM like say .... rxsquelchdelay=xx or rxondelay=xx as I am tring to rid my repeater of a low signal squelch tail while using a PL board(TS-64 in decode only) and with the RTCM providing squelch, A kerchunk will get a long squelch tail ???... was not an issue with the URIx and DSP

have the squelch at 7 turns past minimum gating and still get a long crash ??

Thank you all, in advance, for your time

   Jim Frederick KF6QBW
446.600- 100.0 PL Repeater
   AllStar Node # 28839
         Skype = jim41.2

_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.