Via ssh command line

nano /etc/network/interfaces

### Put the following in

# This file describes the network interfaces available on your system

# and how to activate them. For more information, see interfaces(5).

source /etc/network/interfaces.d/*

# The loopback network interface

auto lo

iface lo inet loopback

# The primary network interface

auto eth0

allow-hotplug eth0

iface eth0 inet static

  address ipaddr

  netmask 255.255.255.255

  broadcast ipaddr

  gateway 192.168.1.1

  dns-nameservers 8.8.8.8

## Just to be sure gateway is working correctly add the below

  post-up /sbin/ip route add Gatewayip  dev eth0

  post-up /sbin/ip route add default via Gatewayip

  pre-down /sbin/ip route delete Gatewayip dev eth0

  pre-down /sbin/ip route delete default via Gatewayip

## End of /etc/network/interfaces

I hope the above helps you in setting your static ip on your system..

Good luck if you need anything just holler!

Loren Tedford (KC9ZHV)
Phone Main: 1+ (631) 686 – 8878 Option 1
Fax: 1-618-551-2755
Email: loren@lorentedford.com
Email: KC9ZHV@KC9ZHV.com
http://www.lorentedford.com
http://www.kc9zhv.com
http://forum.kc9zhv.com
http://hub.kc9zhv.com
http://Ltcraft.net
http://voipham.com

From: CHARLES BENN
Sent: Monday, April 9, 2018 5:56 PM
To: app_rpt-users@lists.allstarlink.org
Subject: [App_rpt-users] Static IP Config

I loaded the new image and did the original set up with DHCP.

I log on to the Console using root enter the info using the  ASL-Menu and save it but the IP remains DHCP.

After hitting OK there is a quick flash of some info at the bottom of the screen but its is gone before I can read it.

Any suggestions

73 Charlie WB2SNN 27904-27908