I am trying to send DTMF codes to an SCOM controller via an AllStar link. I have enabled propagate_dtmf=yes on both sides, and I think the tones are reaching the remote node, but it is not been sent out on the remote end. I have seen references suggesting you this in command mode, but I want the remote node to ignore the tones, and output it to the SCOM instead, so this doesn't seem appropriate.  Does anybody have a HOWTO on this?
73 Willem AC0KQ

================================================================
Dr. Willem A. Schreuder,  President,  Principia Mathematica
Address:  445 Union Blvd, Suite 230,  Lakewood, CO  80228, USA
Tel: (303) 716-3573   Fax: (303) 716-3575
WWW: www.prinmath.com   Email: Willem.Schreuder@prinmath.com
_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.