As far as the BBB, you may not be defining the serial com correctly, but I don't know that from what you have provided for info.

Could you send your entire < [xxxnodeconfig] from rpt.conf > from your acid install to me to understand what is or is not happening.

It's hard to say a thing without more info. Probably a type error and you need other set of eyes.
Also, is it defined as a stand alone RB node
(ie 29261 = radio@127.0.0.1/29261,NONE,y ; ,y =remote base)


...mike/kb8jnm


-------- Original Message --------
Subject: [App_rpt-users] Remote Base setup
From: Sam Nabkey <sam.nabkey@gmail.com>
Date: Sun, November 30, 2014 8:46 am
To: Allstar app_rpt-users Group <app_rpt-users@ohnosec.org>

Hello all...

I have been working on an agile remote base using an Icom 706.  I have seen a lot of posts and read a lot of ideas on using this radio.

I first attemped using this under the Beagle Bone but I didn't have any luck.  SO I switched to an ACID install that was previously working as a Repeater Node.

I first added the remote stuff back to the rpt.conf - and the symptom returned.

The only working config has the line 'remote = ic706' commented out.

Anyone have any ideas on why the USB interface won't start, or the node would die just because the remote statement was added?

I could use some pointers?

--
Samuel T. Nabkey - K8SN



_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.