On Mon, Mar 8, 2010 at 11:45 AM, F6HQZ <f6hqz-m@hamwlan.net> wrote:

Hi men,

IAX provisionning is for the old ATA form Digium, named IAXY or S101i.
The firmware and its config file is pushed to the ATA when registried to
Asterisk.
So, you have no config file for such device in the correct directory,
thats all... No Matter !

Bindaddr is another thing.
May be you haven't defined the Ethernet port to address (0.0.0.0 for all
local ports on the machine is ok) ?

Best 73's from F6HQZ Francois

Le 08/03/2010 13:04, Stephen - K1LNX a écrit :

> I have this exact same issue, I was trying to setup an IAX trunk to
> another machine and encountered the same error upon reload.
>
> I haven't tested it, but I suspect my IAX connections are failing as
> well.
>
> Stephen
> K1LNX
>
> Sent from my iPhone
>
> On Mar 7, 2010, at 10:22, "Ramesh Dhami (VA3UV)"<Ramesh@va3uv.com>
> wrote:
>
>> Hi Guys;
>>
>> One of the nodes that I administer is giving the following error, when
>> trying to do an iax2 reload:
>>
>>
>> iax2 reload
>> == Parsing '/etc/asterisk/iax.conf': Found
>> [Mar 7 10:19:44] NOTICE[2839]: chan_iax2.c:10022 set_config: Ignoring
>> bindaddr on reload
>> == Loaded firmware 'iaxy.bin'
>> [Mar 7 10:19:44] NOTICE[2839]: iax2-provision.c:518
>> iax_provision_reload: No IAX provisioning configuration found, IAX
>> provisioning disabled.
>>
>>
>> Consequently, no IAX connections (inbound or outbound) are being
>> accepted.
>>
>> Any ideas?
>>
>> TIA,
>>
>> Ramesh.
>> _______________________________________________
>> App_rpt-users mailing list
>> App_rpt-users@qrvc.com
>> http://qrvc.com/mailman/listinfo/app_rpt-users
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users@qrvc.com
> http://qrvc.com/mailman/listinfo/app_rpt-users
>
_______________________________________________
App_rpt-users mailing list
App_rpt-users@qrvc.com
http://qrvc.com/mailman/listinfo/app_rpt-users