Actually, just turn the repeater off, then
later back on. Will test this. I see I don't have it in rpt.conf.
Also, how do I tell which version of DIAL I
have installed?
Thanks,
Bob
From: App_rpt-users
[mailto:app_rpt-users-bounces@lists.allstarlink.org] On Behalf Of Bryan D. Boyle
Sent: Friday, May 26, 2017 10:03
AM
To: Users of Asterisk app_rpt
Subject: Re: [App_rpt-users]
Temporary stop, then restart asterisk
cop 3 system disable
--
Sent from my iPhone 6S...No electrons were harmed in the sending of this
message.
Do want to stop AllStar/Asterisk or just turn the repeater off? There
is a COP command for the latter. I'm not in front of a terminal to get you the
command.
tnx
Mike / W5JR
Alpharetta GA
On May 26, 2017, at 11:46 AM, Bob Pyke <k6ecm1@gmail.com> wrote:
Hmmm... sounds like an update is in order :-)
Thanks much,
Bob
Sent from my iPhone
On May 26, 2017, at 8:41 AM, Steve Zingman <szingman@msgstor.com> wrote:
OK,
/etc/init.d/asterisk stop <--- Stop asterisk
killall -9 asterisk <---------------- Make sure it's dead
ps ax | grep asterisk <--- Check to see if it's really dead
/etc/init.d/asterisk start <--- start asterisk
ps ax | grep asterisk <--- Check to see if it's really started
The newer release candidate fixes this.
73, Steve N4IRS
On 5/26/2017 11:37 AM, Bob Pyke wrote:
No. It will be off for several minutes, but I want it to stop when
commanded, and start on command. We are conducting an exercise. I don't know
the version, and logging into the node does not say. We've been operating,
pretty much since the introduction of app_rpt on the RPi
Thanks
Sent from my iPhone
On May 26, 2017, at 8:31 AM, Steve Zingman <szingman@msgstor.com> wrote:
Bob,
Are you talking about "bouncing" asterisk? A stop followed by
a rapid start? Which distribution and version are you running?
73, Steve N4IRS
On 5/26/2017 11:28 AM, Bob Pyke wrote:
I have a need to temporarily disable the repeater, then enable it.
Timing is critical, so a delay is undesirable. What is the best way to accomplish
this? I will be logged into the node.
Thanks,
Bob
Sent from my iPhone
_______________________________________________
App_rpt-users mailing list
App_rpt-users@lists.allstarlink.org
http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users
and scroll down to the bottom of the page. Enter your email address and press
the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email
confirmation. If y