Hi Fredric,
That command list was pulled from the source app_rpt.c and the asterisks are to comment those lines out.  To excute those commands you will need to create a function.  I put them under [functions] in /etc/asterisk/rpt.conf.  For example:

[functions]
900 = cop,58        ;Tx CTCSS On Input only Enable
901 = cop,59        ;Tx CTCSS On Input only Disable

A *900 will execute TX CTCSS Enable, *901 will execute TX CTCSS Disable.

Also Allstarnode.com is not maintained by the developers of app_rpt, it is a third party site.  The current site for configuration information is http://ohnosec.org/drupal.  The variable you are looking for is documented at http://ohnosec.org/drupal/node/176.


Monty


On Sun, Jan 1, 2012 at 2:04 AM, Fredric Moses <fred@moses.bz> wrote:
I am working on getting a logic output to run my PL encoder for COR active PL on the main repeater port.  using a variable i was able to get it to work fine with local RX audio. When a signal is present I have a gpio pin going low.. when not present going back high..   but can not find a variable to watch for IP links coming in. Is there one?  Is there something I can watch so that I can make the logic pin swing..?

Some google foo found these commands
* 56 - Rx CTCSS Enable
* 57 - Rx CTCSS Disable
* 58 - Tx CTCSS On Input only Enable
* 59 - Tx CTCSS On Input only Disable
http://allstarnode.com/viewtopic.php?f=5&t=8

The only mention I see of TX PL is with use of a USB radio interface.  Will *58 follow the tx pl settings set in usbradio if I had a USB radio device vs using one of the LOX ports for the main repeater..

--
Fredric Moses - W8FSM - WQOG498
fred@moses.bz




_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users