holdofftelem = 0 ; Hold off all telemetry when signal is
present on receiver or from connected nodes
; except when an ID needs to
be done and there is a signal coming from a connected node.
telemdefault = 1 ; 0 = telemetry output off
; 1 = telemetry output on
(default = 1)
; 2 = timed telemetry output
on command execution and for a short time thereafter.
telemdynamic = 1 ; 0 = disallow users to change the local
telemetry setting with a COP command,
; 1 = Allow users to change
the setting with a COP command. (default = 1)
Hello,
I've been searching through my email archive and the Asterisk
documentation for help in changing my node configuration so it
doesn't
announce all of the remote node connect / disconnect messages over
my node.
If I read things correctly, the change should be made in rpt.conf
with
Telemdefault=1 and changed to =2. For some reason I do not find
this
line in my rpt.conf file.
I am using Dial with Debian, although I plan to move to a
Raspberry Pi 3
before long.
Thanks!
Dave
---
This email has been checked for viruses by Avast antivirus
software.
https://www.avast.com/antivirus
_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and
scroll down to the bottom of the page. Enter your email address
and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email
confirmation. If you have trouble unsubscribing, please send a
message to the list detailing the problem.
--
"Just say no to world domination"