Ah ha, trying #3 below I get “Device usb currently not active”. There’s a clue…
Please enter your selection now: T
Transmit Test Tone/Keying is now Enabled
active (command) USB Radio device is [usb]
1) Select USB device
2) Set Rx Voice Level (using display)
3) Set Transmit A Level and send test tone
4) Set Transmit B Level and send test tone
E) Toggle Echo Mode (currently Disabled)
F) Flash (Toggle PTT and Tone output several times)
P) Print Current Parameter Values
S) Swap Current USB device with another USB device
T) Toggle Transmit Test Tone/Keying (currently Enabled)
W) Write (Save) Current Parameter Values
0) Exit Menu
Please enter your selection now: 3
Device usb currently not active
Enter new Tx A Level setting (0-999, or C/R for none):
From: Will Bashlor [mailto:will@bashlor.com]
Sent: Wednesday, December 13, 2017 9:32 AM
To: 'Users of Asterisk app_rpt' <app_rpt-users@lists.allstarlink.org>
Subject: RE: [App_rpt-users] Changing from radioless dahdi to simpleusb
Nm, I forgot sudo. Shame on me lol. I get so used to no sudo it’s hard to remember. I’ll go through and see what it will allow me to setup…
From: Will Bashlor [mailto:will@bashlor.com]
Sent: Wednesday, December 13, 2017 9:12 AM
To: 'Users of Asterisk app_rpt' <app_rpt-users@lists.allstarlink.org>
Subject: RE: [App_rpt-users] Changing from radioless dahdi to simpleusb
Thanks for the replies. It seems Linux sees the CM108 FOB, but it's like AllStar isn't communicating with it. Is there a setting somewhere to tell it what USB bus and port to use, or does it find it automatically? I also tried to use simpleusb-tune-menu to configure it but I get the error below.
pi@raspberrypi:/usr/sbin $ ./simpleusb-tune-menu
Error parsing device parameters
pi@raspberrypi:/usr/sbin $
-----Original Message-----
From: App_rpt-users [mailto:app_rpt-users-bounces@lists.allstarlink.org] On Behalf Of Bryan Fields
Sent: Tuesday, December 12, 2017 3:51 PM
To: Users of Asterisk app_rpt <app_rpt-users@lists.allstarlink.org>
Subject: Re: [App_rpt-users] Changing from radioless dahdi to simpleusb
On 12/12/17 3:42 PM, Steve Zingman wrote:
> dahdi/pseudo needs chan_dahdi.so
I stand corrected. I forgot about the pseudo driver.
--
Bryan Fields
727-409-1194 - Voice
_______________________________________________
App_rpt-users mailing list
App_rpt-users@lists.allstarlink.org
http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.