I found this on batboard and kept it in my file. FYI.
Connect URI to MSF5000
CODE: SELECT ALL
MSF SSCB---------URI
TP9 (Mic PTT)------1
TP8 (Mic Audio)---22
TP3 (Disc Audio)--21
TP7 (Ground)------13
Passes audio and CTCSS just fine. This was for a setup where the URI was handling CTCSS
encode/decode and TX qualification so no COR signal was necessary. I set the receiver qualification
to "ON" in the MSF Channel programming and set my PTT priority to "L".
http://batboard.batlabs.com/viewtopic.php?f=10&t=95382&p=420413&hilit=allstar#p448058
73,
Eric
4Z5UG / WA6IGR
Allstar Node: 28422
Israel Direct: 077-950-9451
USA Direct: +1-720-377-3840
Skype: ericrguth
From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of James Smith
Sent: Saturday, January 26, 2013 1:48 AM
To: app_rpt-users@ohnosec.org
Subject: [App_rpt-users] uri to msf5000 interface - ever done one?
not enough tx audio problem ive been having.
i cant get anymore than 1.1khz max dieviation out of it using the uri.
if i use the uri amplifier to boost the audio , i get somewhere around 2.5khz, i am able to her that it is clearly distorted and choppy audio.
so , ive got a digital capable uhf r2 msf5000. it worked great as a stand alone ham band repeater on 442.925 and the audio - everything was fine using its own controller.
so i changed the codeplug to what some guy WA1??? on repeater-builder recommended for the settings for using an external controller. because i want the allstar box to control the whole box. i preferred dsp for audio.
i soldered to the TP2 ,3,4,and TP9 test point to get my audio and everything else. i want to use those because it said the tp for reciever audio is pre-emphasis. so all the wires go to one area and then all my connections are soldered to the corresponding TestPoint connectors.
so i tried making a interface cable to the j2 side mount plug (the 25pin on the side of the station) same result on audio. i used line 2+ and line 4+ for the audio. With the audio maxed out -still 1.1 khz coming out with no audio amp and about 2.6khz and distorted and choppy coming out with the audio amp.
anything come to mind?
i hope to get this figured out , so i can interface the next msf. where did y'all interface your uri's to an msf?
thanks so much ,
james kd5oxm